SC16C2550B datasheet(21/43 Pages) PHILIPS

21 / 43 page

SC16C2550B_4

Product data sheet

Rev. 04 — 15 February 2007

21 of 43

NXP Semiconductors

SC16C2550B

5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 16-byte FIFOs

7.6 Modem Control Register (MCR)

This register controls the interface with the modem or a peripheral device.

Table 16.

LCR[2] stop bit length

LCR[2]

Word length (bits)

Stop bit length (bit times)

5, 6, 7, 8

⁄

6, 7, 8

Table 17.

LCR[1:0] word length

LCR[1]

LCR[0]

Word length (bits)

005

016

107

118

Table 18.

Modem Control Register bits description

Bit

Symbol

Description

7:5

MCR[7:5]

reserved; set to ‘0’

MCR[4]

Loop-back. Enable the local Loop-back mode (diagnostics). In this mode

the transmitter output (TX) and the receiver input (RX), CTS, DSR, CD and

RI are disconnected from the SC16C2550B I/O pins. Internally the modem

data and control pins are connected into a loop-back data conﬁguration

(see Figure 7). In this mode, the receiver and transmitter interrupts remain

fully operational. The Modem Control Interrupts are also operational, but

the interrupts’ sources are switched to the lower four bits of the Modem

Control. Interrupts continue to be controlled by the IER register.

logic 0 = disable Loop-back mode (normal default condition)

logic 1 = enable local Loop-back mode (diagnostics)

MCR[3]

OP2/INT enable

logic 0 = forces INT (A, B) outputs to the 3-state mode and sets OP2 to a

logic 1 (normal default condition)

logic 1 = forces the INT (A, B outputs to the active mode and sets OP2 to

a logic 0

MCR[2]

(OP1). OP1A/OP1B are not available as an external signal in the

SC16C2550B. This bit is instead used in the Loop-back mode only. In the

Loop-back mode, this bit is used to write the state of the modem RI

interface signal.

MCR[1]

RTS

logic 0 = force RTS output to a logic 1 (normal default condition)

logic 1 = force RTS output to a logic 0

MCR[0]

DTR

logic 0 = force DTR output to a logic 1 (normal default condition)

logic 1 = force DTR output to a logic 0

SC16C2550B 데이터시트(PDF) 21 Page - NXP Semiconductors

SC16C2550B 데이터시트(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

데이터시트 다운로드

링크 URL