5.2

Connecting Power Cables

Power cords for use outside of the United States must be ordered separately. Ensure that the power cord is

compliant with local and national electrical codes.

The router accommodates two power supplies. At least one power supply must connect to a power source.

Connecting both power supplies provides redundancy protection. Rear Panel section displays the location of

the power supplies on the rear panel of the router.

•

Non-redundant configuration: Connect power to either of the two power supplies.

•

Redundant power supply configuration: Connect power to both power supplies.

•

Power down the router: Remove all power cords and wires from the power supplies.

Important: Installation of this equipment must comply with local and national electrical codes.

If necessary, consult with the appropriate regulatory agencies and inspection authorities to

ensure compliance.

Installation de cet équipement doit être conformes aux codes électriques locaux et nationaux. Si

nécessaire, consulter les organismes de réglementation appropriés et des autorités de contrôle pour

assurer la conformité.

Important: Read all installation instructions before connecting the system to the power source.

Lire toutes les instructions d’installation avant de brancher le système à la source d’alimentation.

Important: This equipment must be grounded. Never defeat the ground conductor.

Cet équipement doit être mis à la terre. Ne jamais modifier le conducteur de terre.

Important: This unit requires overcurrent protection.

Cet appareil requiert une protection contre les surintensités.

5.2.1

AC Power Supplies

The following AC power supplies are supported:

•

PWR-00619-01 (AWE-5310)

•

PWR-00618-01 (AWE-5510)

18

The following image displays an AC power supply, including the power socket on the left side of the module.

The AC power supply connects to a circuit that provides the required power, as specified in the Specifications

section.

Figure 5-4: AC Power Supply (Example)