M93C86 datasheet(16/38 Pages) STMICROELECTRONICS

16 / 38 page

Instructions

M93C86, M93C76, M93C66, M93C56, M93C46

16/38

5.4

Write

For the Write Data to Memory (WRITE) instruction, 8 or 16 data bits follow the op-code and

address bits. These form the byte or word that is to be written. As with the other bits, Serial

Data Input (D) is sampled on the rising edge of Serial Clock (C).

After the last data bit has been sampled, the Chip Select Input (S) must be taken low before

the next rising edge of Serial Clock (C). If Chip Select Input (S) is brought low before or after

this specific time frame, the self-timed programming cycle will not be started, and the

addressed location will not be programmed. The completion of the cycle can be detected by

monitoring the READY/BUSY line, as described later in this document.

Once the Write cycle has been started, it is internally self-timed (the external clock signal on

Serial Clock (C) may be stopped or left running after the start of a Write cycle). The cycle is

automatically preceded by an Erase cycle, so it is unnecessary to execute an explicit erase

instruction before a Write Data to Memory (WRITE) instruction.

Figure 5.

ERASE, ERAL sequences

For the meanings of An and Xn, please see Table 5., Table 6. and Table 7..

5.5

Erase All

The Erase All Memory (ERAL) instruction erases the whole memory (all memory bits are set

to 1). The format of the instruction requires that a dummy address be provided. The Erase

cycle is conducted in the same way as the Erase instruction (ERASE). The completion of

the cycle can be detected by monitoring the READY/BUSY line, as described in the

READY/BUSY status section.

AI00879B

ERASE

1 1

ADDR

CODE

BUSY

READY

CHECK

STATUS

ERASE

ALL

CODE

BUSY

READY

CHECK

STATUS

Xn X0

ADDR

M93C86 데이터시트(PDF) 16 Page - STMicroelectronics

M93C86 데이터시트(HTML) 16 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

데이터시트 다운로드

링크 URL