MPC8280 datasheet(811/1386 Pages) FREESCALE

811 / 1386 page

SCC Ethernet Mode

MPC8280 PowerQUICC II Family Reference Manual, Rev. 1

Freescale Semiconductor

25-23

23. Write 0x0040_0000 to the SIU interrupt mask register low (SIMR_L) so the SMC1 can generate a

system interrupt. Initialize SIU interrupt pending register low (SIPNR_L) by writing

0xFFFF_FFFF to it.

24. Write 0x0000_0000 to GSMR_H2 to enable normal operation of all modes.

25. Write 0x1088_000C to the GSMR_L2 register to configure CTS (CLSN) and CD (RENA) to

automatically control transmission and reception (DIAG bits) and the Ethernet mode. TCI is set to

allow more setup time for the EEST to receive the MPC8280 transmit data. TPL and TPP are set

for Ethernet requirements. The DPLL is not used with Ethernet. Note that the ENT and ENR are

not enabled yet.

26. Write 0xD555 to the DSR.

27. Set the PSMR2 to 0x0A0A to configure 32-bit CRC, promiscuous mode, and begin searching for

the start frame delimiter 22 bits after RENA2 (CD2).

28. Write 0x1088_003C to GSMR_L2 to enable the SCC2 transmitter and receiver. This

additional write ensures that ENT and ENR are enabled last.

After 14 bytes and the 46 bytes of automatic pad (plus the 4 bytes of CRC) are sent, the TxBD is closed.

Additionally, the receive buffer is closed after a frame is received. Any data received after 1520 bytes or

a single frame causes a busy (out-of-buffers) condition because only one RxBD is prepared.

MPC8280 데이터시트(PDF) 811 Page - Freescale Semiconductor, Inc