DNA Pro series

10K8 • 3K8

2196 Hilton Drive, Suite E Gainesville, GA, U.S.A 30501

Telephone: 877-419-5805

Email: info@danleysoundlabs.com

Protections Systems

Under all circumstances the control and protection systems will endeavour to deliver the maximum power possible for a given set of

conditions, applying limiters only in extreme circumstances. Muting will only occur when a dangerous situation is detected, normal

operation automatically resuming when the condition clears.

System protection

Speaker protection

Excessive power supply current or amplifier output current

Sustained clipping prevention

Excessive temperature per sub system: PSU, amplifier and DSP

DC offset protection

Mains voltage within acceptable limits

Excessive HF energy (VHF) limiter

Internal power rails producing correct output

Fans operating at correct speed

VX audio output limiters

Vx provides a linear phase virtual crossover and two limiter paths on

each output. This unique system delivers effective protection for

systems that incorporate passive crossovers.

Power distribution protection systems

Vx Limit

Multiband peak limiter, two per output

Mains inrush current limiting for soft start and anti-surge

Vx Max

Multiband overshoot limiter, two per output

Mains average current limiting for mains breaker management

X-Max

Driver excursion limiter

Randomized initialization when remotely powered up

T-Max

Driver thermal limiter (long term power limiter)

Monitoring, measurements recorded against time

Monitoring, device statistics and counters

Supply current

Number of power cycles counted

Supply voltage

Number of mains brownout events counted

Thermal Capacity

Fan speeds continuously monitored

Each driver current

Fan under-speed events counted

Each driver impedance

Various protection mute events counted

Protection limiting for each output

Driver Impedance continuously monitored

An inbuilt alarm and notification system to indicate problems to remote devices either via the network or the Volt-free changeover relay

contacts accessibly on the rear panel.

Physical

Cooling

Dual vari-speed fans, front to back airflow. Washable, tool less change filter media.

Analog IN and LINK

Phoenix pluggable terminal block

AES3 dual channel IN and LINK

Phoenix pluggable terminal block

Amplifiers output

4x Neutrik SpeakonTM NL4 connectors

Mains input connector

Neutrik 32A PowerconTM

Dante Primary and Secondary

2x Shielded RJ45

Relay output & contact closure inputs/output

Phoenix pluggable terminal block

LED indicators

Bright, easily differentiated

Enclosure

Standard 19” 2U (88mm), 357mm (14”) deep with handles and optional rear support

Net Weight

27.5 pounds (12.5kg)

Rear Support Kit

DNA-RSK