This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

or modifications due to changes in technical specifications.

17

EN25F80

Rev. D, Issue Date: 2007/05/16

Figure 13 Block Erase Instruction Sequence Diagram

Chip Erase (CE) (C7h/60h)

The Chip Erase (CE) instruction sets all bits to 1 (FFh). Before it can be accepted, a Write Enable (WREN)

instruction must previously have been executed. After the Write Enable (WREN) instruction has been

decoded, the device sets the Write Enable Latch (WEL).

The Chip Erase (CE) instruction is entered by driving Chip Select (CS#) Low, followed by the instruction

code on Serial Data Input (DI). Chip Select (CS#) must be driven Low for the entire duration of the

sequence.

The instruction sequence is shown in Figure 14. Chip Select (CS#) must be driven High after the eighth bit

of the instruction code has been latched in, otherwise the Chip Erase instruction is not executed. As soon

While the Chip Erase cycle is in progress, the Status Register may be read to check the value of the Write

In Progress (WIP) bit. The Write In Progress (WIP) bit is 1 during the self-timed Chip Erase cycle, and is 0

when it is completed. At some unspecified time before the cycle is completed, the Write Enable Latch

(WEL) bit is reset.

The Chip Erase (CE) instruction is executed only if all Block Protect (BP2, BP1, BP0) bits are 0. The Chip

Erase (CE) instruction is ignored if one, or more, sectors are protected.

Figure 14. Chip Erase Instruction Sequence Diagram