ADIN1111BCPZ-R7 datasheet(17/109 Pages) AD

17 / 109 page

Data Sheet

ADIN1111

HARDWARE CONFIGURATION PINS

analog.com

Rev. A | 17 of 109

Transmit Amplitude

The TX2P4_EN hardware configuration pin allows the user to

configure the required transmit amplitude mode for the intended ap-

plication (see Table 14). If TX2P4_EN is pulled low, the ADIN1111

is configured by default to support both 1.0 V p-p and 2.4 V p-p

transmit levels, decided by autonegotiation. If TX2P4_EN is pulled

high, the ADIN1111 is configured to disable 2.4 V p-p transmit

operating mode by default and operate with 1.0 V p-p transmit

level only. If the TX2P4_EN pin is strapped high (1.0 V p-p only),

the associated register cannot be changed through the SPI. For

example, 2.4 V p-p operation is not possible if the ADIN1111 is

hardware pin configured for 1.0 V p-p only.

The 1.0 V p-p transmit operating mode can operate at a lower

AVDD_H supply voltage of 1.8 V.

The higher transmit operating mode of 2.4 V p-p requires a higher

AVDD_H supply voltage of 3.3 V. This mode can be used for longer

cable lengths in industrial Ethernet environments with high noise

levels.

Table 14. Transmit Amplitude Configuration (Hardware Configuration)

Transmit Amplitude Selection

TX2P4_EN

1.0 V p-p or 2.4 V p-p

1.0 V p-p

SPI Protocol Configuration

The ADIN1111 allows the use of a generic SPI protocol with or

without the use of CRC, or the OPEN Alliance SPI protocol with or

without protection.

Table 15. SPI Protocol (Hardware Configuration)

SPI Protocol

SPI_CFG1

SPI_CFG0

OPEN Alliance with Protection

OPEN Alliance Without Protection

Generic SPI with 8-bit CRC

Generic SPI Without 8-bit CRC

ADIN1111BCPZ-R7 데이터시트(PDF) 17 Page - Analog Devices