| 전자부품 데이터시트 검색엔진 |
|
ACT72350 데이터시트(PDF) 27 Page - Qorvo, Inc |
|
|
|||||||||||||||||||||||||||||
ACT72350 데이터시트(HTML) 27 Page - Qorvo, Inc |
|
27 / 97 page ![]() ACT72350 Data Sheet 160V 3 Phase BLDC Motor Driver Data Sheet v1.1, 2025-02-17 Subject to change without notice 27 of 97 www.qorvo.com ® microcontroller upon re-initialization to determine the cause of previous reset. This information is stored within the SOC.FAULT.TMPFLT bit A power monitoring signal VMON is provided onto the AIO6 buffered output for monitoring various internal power supplies. VMON can be set to be one of the following monitored supplies: 0.4•VCC33, 0.4•VCCIO, 0.4•VSYS, VPTAT1 or 0.1•VP. For power and temperature warning, an IC temperature warning event at 140°C are provided as a maskable interrupt source into the application microcontroller, through the nFAULT output. This warning could be employed to instruct the microcontroller to safely power down the system. To allow Temperature Warning assertions on the nFAULT open drain output, write to the SOC.FAULTENABLE.nTMPWARN bit. Alternatively, the external microcontroller can obtain the real time status temperature warning bit by reading the SOC.FAULT.TMPWARN bit. If the Temperature Warning fault issues a fault message, the state of this fault is latched within the SOC.FAULT.TMPWARN_LATCH. In addition to the temperature warning interrupt and fault reset, a temperature monitor signal is provided onto the AIO6 buffered output as an analog signal, which the application microcontroller can choose to capture using its ADC resource, as a means to measure internal die temperature. 11.10 Voltage Reference The reference block includes a 1.2V high-precision reference voltage used internally and for all the LDOs. There is also a high-accuracy 2.5V/3.0V programmable reference for the ADC VREF. There is also a 4- level programmable threshold voltage VTHREF (0.1V, 0.2V, 0.5V, and 1.25V) . 1 VPTAT is voltage proportional with absolute temperature from the temperature sensing circuit. The VPTAT voltage can be sampled by the external microcontroller’s ADC through the voltage monitoring MUX at AO6, while AIO6 is in Output Buffer Mode . |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |