BMP388 datasheet(42/59 Pages) BOSCH

42 / 59 page

Bosch Sensortec | BMP388 Datasheet

42 | 59

Modifications reserved |Data subject to change without notice | Printed in Germany

Document number: BST-BMP388-DS001-07 Revision_1.7_112020

5.3.

SPI interface

The SPI interface is compatible with SPI mode ‘00’ (CPOL = CPHA = ‘0’) and mode ‘11’ (CPOL = CPHA = ‘1’). The automatic

selection between mode ‘00’ and ‘11’ is determined by the value of SCK after the CSB falling edge.

The SPI interface has two modes: 4-wire and 3-wire. The protocol is the same for both. The 3-wire mode is selected by

setting spi3=‘1’ in register “IF_CONF[0]” (see 4.3.13). The pad SDI is used as a data input/output pad in 3-wire mode.

The SPI interface uses the following pins:

•

CSB: chip select, active low

•

SCK: serial clock

•

SDI:

serial data input; data input/output in 3-wire mode

•

SDO: serial data output; hi-Z in 3-wire mode

Refer to chapter 6 for connection instructions.

CSB is active low and has an integrated pull-up resistor. Data on SDI is latched by the device at SCK rising edge and SDO

is changed at SCK falling edge. Communication starts when CSB goes to low and stops when CSB goes to high; during

these transitions on CSB, SCK must be stable. The SPI protocol is shown in Figure 17.

CSB

SCK

SDI

AD6 AD5 AD4 AD3 AD2 AD1 AD0

DI5

DI4

DI3

DI2

DI1

DI0

DI7

DI6

SDO

DO5 DO4 DO3 DO2 DO1 DO0

DO7 DO6

tri-state

Figure 17: SPI protocol (shown for mode ‘11’ in 4-wire configuration)

In SPI mode, only 7 bits of the register addresses are used; the MSB of register address is not used and replaced by a

read/write bit (RW = ‘0’ for write and RW = ‘1’ for read).

Example: address 0xF7 is accessed by using SPI register address 0x77. For write access, the byte 0x77 is transferred, for

read access, the byte 0xF7 is transferred.

5.3.1. SPI write

Writing is done by lowering CSB and sending pairs control bytes and register data. The control bytes consist of the SPI

register address (= full register address without bit 7) and the write command (bit7 = RW = ‘0’). Several pairs can be written

without raising CSB. The transaction is ended by a raising CSB. The SPI write protocol is depicted in Figure 18.

Figure 18: 4 wire SPI sequence

Figure 19: SPI multiple write

BMP388 데이터시트(PDF) 42 Page - Bosch Sensortec GmbH

BMP388 데이터시트(HTML) 42 Page - Bosch Sensortec GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59

데이터시트 다운로드

링크 URL