STDRIVE102H datasheet(38/56 Pages) STMICROELECTRONICS

38 / 56 page

The typical sequence for the supplies is:

•

VDD UVLO is released (VDD > VDD(On)): the analog voltage on TCC/IGATE is now valid and the AFE is

operative. The internal ADC can acquire the TCC/IGATE configuration, taking approximately 100 µs.

•

VCC UVLO is released (VCC > VCC(On)): the low-side drivers are operative.

•

Charge pump UVLO is released (VBOOT - VM > VCPump(On)): the high-side drivers are operative.

Following the release of all the UVLO protections, the nFAULT pin is set high by the external pull-up resistor.

5.8

Standby and wake-up

The standby pin is active low (nSTBY = 0: standby mode, nSTBY = 1: normal mode). The standby mode strongly

reduces the current consumption down to ISTBY. The commutation to standby mode, which takes a tSTBY to be

completed, follows a sequence of steps managed by the internal logic:

1. Before being disabled, all the drivers turn off the external MOSFETs. Then, the VGS of the external MOSFET

is kept low by the internal 100 kΩ pull-down resistor, present on the GHSx/GLSx pins.

2. The AFE is disabled.

3. Both the linear regulators and the charge pump are switched off to reduce current consumption.

4. Open-drain pins are released.

5. The internal logic enters the standby state, and most of its circuitries are disabled.

It is always preferable to force nSTBY = 0 before removing the main supply VS in the turn-off sequence of the

device.

When the nSTBY pin returns high, the device leaves the standby mode following the wake-up sequence:

1. Internal logic is initialized.

2. The linear regulators and the charge pump are turned on.

3. The AFE becomes active.

The device can be considered operative as soon as its supplies (VCC, VDD, and VBOOT) are stable above the

respective UVLO thresholds (nFAULT open-drain released).

STDRIVE102BH, STDRIVE102H

Device description

DS14545 - Rev 1

page 38/56

STDRIVE102H 데이터시트(PDF) 38 Page - STMicroelectronics