LT6005CDHC datasheet(7/20 Pages) LINER

7 / 20 page

LT6003/LT6004/LT6005

600345f

(LT6003H, LT6004H, LT6005H) The ● denotes the speciﬁcations which

apply over the full speciﬁed temperature range of –40°C ≤ TA ≤ 125°C. VS = ±8V, VCM = VOUT = half supply, RL to ground, unless

otherwise noted.

ELECTRICAL CHARACTERISTICS

SYMBOL

PARAMETER

CONDITIONS

MIN

TYP

MAX

UNITS

VOS

Input Offset Voltage

LT6003S5, LT6004MS8

LT6005GN

LT6004DD, LT6005DHC

LT6003DC

●

1.6

1.8

2.2

ΔVOS/ΔT

Input Offset Voltage Drift (Note 5)

S5, MS8, GN

DC, DD, DHC

●

µV/°C

Input Bias Current

LT6003

LT6004, LT6005

●

IOS

Input Offset Current

LT6003

LT6004, LT6005

●

CMRR

Common Mode Rejection Ratio

VCM = –7.7V to 6.9V

VCM = –7.7V to 7.7V, S5, MS8, GN

VCM = –7.7V to 7.7V, DC, DD, DHC

●

Input Offset Voltage Shift

VCM = –7.7V to 6.9V

VCM = –7.7V to 7.7V, S5, MS8, GN

VCM = –7.7V to 7.7V, DC, DD, DHC

●

460

1.9

2.5

µV

Input Voltage Range

Guaranteed by CMRR

●

–7.7

7.7

PSRR

Power Supply Rejection Ratio

VS = ±1.1V to ±8V

●

VOL

Output Swing Low (Notes 6, 8)

No Load

ISINK = 100µA

●

275

VOH

Output Swing High (Note 6)

No Load

ISOURCE = 100µA

●

140

400

ISC

Short Circuit Current

Short to GND

●

1mA

Supply Current per Ampliﬁer

●

3µA

Slew Rate (Note 8)

AV = –1, RF = RG = 1MΩ

●

0.2

V/ms

Note 1: Stresses beyond those listed under Absolute Maximum Ratings

may cause permanent damage to the device. Exposure to any Absolute

Maximum Rating condition for extended periods may affect device

reliability and lifetime.

Note 2: A heat sink may be required to keep the junction temperature

below absolute maximum. This depends on the power supply voltage and

how many ampliﬁers are shorted. The θJA specﬁed for the DC, DD and

DHC packages is with minimal PCB heat spreading metal. Using expanded

metal area on all layers of a board reduces this value.

Note 3: The LT6003C/LT6004C/LT6005C and LT6003I/LT6004I/LT6005I are

guaranteed functional over the temperature range of –40°C to 85°C. The

LT6003H/LT6004H/LT6005H are guaranteed functional over the operating

temperature range of –40°C to 125°C.

Note 4: The LT6003C/LT6004C/LT6005C are guaranteed to meet speciﬁed

performance from 0°C to 70°C. The LT6003C/LT6004C/LT6005C are

designed, characterized and expected to meet speciﬁed performance from

–40°C to 85°C but are not tested or QA sampled at these temperatures.

The LT6003I/LT6004I/LT6005I are guaranteed to meet speciﬁed

performance from –40°C to 85°C. The LT6003H/LT6004H/LT6005H are

guaranteed to meet speciﬁed performance from –40°C to 125°C.

Note 5: This parameter is not 100% tested.

Note 6: Output voltage swings are measured between the output and

power supply rails.

Note 7: Limits are guaranteed by correlation to VS = 5V tests.

Note 8: Limits are guaranteed by correlation to VS = 1.8V tests

Note 9: Limits are guaranteed by correlation to VS = ±8V tests

Note 10: Full-power bandwidth is calculated from the slew rate:

FPBW = SR/πVP-P.

LT6005CDHC 데이터시트(PDF) 7 Page - Linear Technology

LT6005CDHC 데이터시트(HTML) 7 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

데이터시트 다운로드

링크 URL