Easy validation of Bluetooth transmitter with push button preset, pass/fail information and

clear correlation between displays.

Mapping

The MAP application enables interference hunting and location analysis.

Locate interference with an azimuth function that lets you draw a line or an

arrow on a mapped measurement to indicate the direction your antenna

was pointing when you took a measurement. You can also create and

display measurement labels.

Mapped channel power readings using the azimuth function.

LTE FDD and TDD base station transmitter

RF testing

Option SV28 enables the following LTE measurements:

Cell ID

Channel Power

Occupied Bandwidth

Adjacent Channel Leakage Ratio (ACLR)

Spectrum Emission Mask (SEM)

Transmitter Off Power for TDD

There are four presets to accelerate pre-compliance testing and determine

the Cell ID. These presets are defined as Cell ID, ACLR, SEM, Channel

Power and TDD Toff Power. The measurements follow the definition in

3GPP TS Version 12.5 and support all base station categories, including

picocells and femtocells. Pass/Fail information is reported and all channel

bandwidths are supported.

The Cell ID preset displays the Primary Synchronization Signal (PSS) and

the Secondary Synchronization Signal (SSS) in a Constellation diagram. It

also provides Frequency Error.

The ACLR preset measures the E-UTRA and the UTRA adjacent channels,

with different chip rates for UTRA. ACLR also supports Noise Correction

based on the noise measured when there is no input. Both ACLR and SEM

will operate in swept mode (default) or in faster single acquisition if the

instrument has enough acquisition bandwidth.

Fast validation of LTE base station transmitter with push button preset, and pass/fail

information

SignalVu-PC-SVE Vector Signal Analysis Software

6 www.tek.com