IP113MLF-DS-R09 datasheet(33/58 Pages) ETC2

33 / 58 page

IP113M LF

Preliminary Data Sheet

33/58

April 9, 2007

IP113M LF-DS-R11

The basic MII registers 1(continued)

MII

NAME

R/W

DESCRIPTION

DEFAULT

MII status register (address 01h)

1.4

Remote fault

1 = remote fault detected

0 = not remote fault detected

When read as logic 1, indicates that IP113M LF

has detected a remote fault condition. This bit is

set until remote fault condition gone and before

reading the contents of the register. This bit is

cleared after IP113M LF reset.

1.3

Auto-Negotiation

Ability

1 = Auto-Negotiation capable

0 = not Auto-Negotiation capable

When read as logic 1, indicates that IP113M LF

has the ability to perform Auto-Negotiation. The

value of this bit will depend on the external mode

setting of IP113M LF operation mode.

1.2

Link Status

1 = Link Pass

0 = Link Fail

When read as logic 1, indicates that IP113M LF

has determined a valid link has been established.

When read as logic 0, indicates the link is not valid.

This bit is cleared until a valid link has been

established and before reading the contents of this

registers.

1.1

Jabber Detect

1 = jabber condition detected

0 = no jabber condition detected

When read as logic 1, indicates that IP113M LF

has detected a jabber condition. This bit is always

0 for 100Mbps operation and is cleared after

IP113M LF reset. This bit is set until jabber

condition is cleared and reading the contents of the

1.0

Extended capability

1 = Extended register capabilities

0 = No extended register capabilities

IP113M LF has extended register capabilities.

IP113MLF-DS-R09 데이터시트(PDF) 33 Page - List of Unclassifed Manufacturers

IP113MLF-DS-R09 데이터시트(HTML) 33 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

데이터시트 다운로드

링크 URL