TSC2005 datasheet(11/46 Pages) TI2

11 / 46 page

www.ti.com

TOUCH SCREEN OPERATION

4-WIRE TOUCH SCREEN COORDINATE PAIR MEASUREMENT

ConductiveBar

InsulatingMaterial(Glass)

Silver

Ink

TransparentConductor(ITO)

BottomSide

Transparent

Conductor(ITO)

TopSide

X+

X-

Y+

Y-

ITO=IndiumTinOxide

TOUCH

+ RX−plate @

Postition

4096

* 1

(1)

TOUCH

X−plate

@ XPostition

4096

*1 *RY−plate @ 1*

Position

4096

(2)

TSC2005

SBAS379C – DECEMBER 2006 – REVISED MARCH 2008

A resistive touch screen operates by applying a voltage across a resistor network and measuring the change in

resistance at a given point on the matrix where the screen is touched by an input (stylus, pen, or finger). The

change in the resistance ratio marks the location on the touch screen.

The TSC2005 supports the resistive 4-wire configurations, as shown in Figure 21. The circuit determines location

in two coordinate pair dimensions, although a third dimension can be added for measuring pressure.

A 4-wire touch screen is typically constructed as shown in Figure 21. It consists of two transparent resistive

layers separated by insulating spacers.

Figure 21. 4-Wire Touch Screen Construction

The 4-wire touch screen panel works by applying a voltage across the vertical or horizontal resistive network.

The A/D converter converts the voltage measured at the point where the panel is touched. A measurement of the

Y position of the pointing device is made by connecting the X+ input to a data converter chip, turning on the Y+

and Y– drivers, and digitizing the voltage seen at the X+ input. The voltage measured is determined by the

voltage divider developed at the point of touch. For this measurement, the horizontal panel resistance in the X+

lead does not affect the conversion because of the high input impedance of the A/D converter.

Voltage is then applied to the other axis, and the A/D converter converts the voltage representing the X position

on the screen. This process provides the X and Y coordinates to the associated processor.

Measuring touch pressure (Z) can also be done with the TSC2005. To determine pen or finger touch, the

pressure of the touch must be determined. Generally, it is not necessary to have very high performance for this

test; therefore, 10-bit resolution mode is recommended (however, data sheet calculations are shown using 12-bit

resolution mode). There are several different ways of performing this measurement. The TSC2005 supports two

methods. The first method requires knowing the X-plate resistance, the measurement of the X-Position, and two

additional cross panel measurements (Z2 and Z1) of the touch screen (see Figure 22). Equation 1 calculates the

touch resistance:

The second method requires knowing both the X-plate and Y-plate resistance, measurement of the X-Position

and the Y-Position, and Z1. Equation 2 also calculates the touch resistance:

Submit Documentation Feedback

Product Folder Link(s): TSC2005

TSC2005 데이터시트(PDF) 11 Page - Texas Instruments

TSC2005 데이터시트(HTML) 11 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

데이터시트 다운로드

링크 URL