SCALE Driver

2SD315AI Data Sheet

IGBT-Driver.com

Page 13

(everything OK) and goes out when the driver detects an undervoltage or during the

blocking time.

3k3

SCALEdriver

Visox

LSx

OkayLED

isolated+16V

Ds

COMx

Fig. 6 Status display with LED at pin LSx

Attention:

The Schottky diode Ds should not be omitted if the local status outputs are used. If the

local status outputs are not used, LS1 should be connected to COM1 and LS2 to COM2

in order to increase the noise immunity of the driver.

Configuration within the Power Section

The drivers should be located as closely as possible to the power transistors. The

connecting leads to the transistors should be as short as possible and as low inductance

as possible, i.e. they can be up to 3cm to 10cm long depending on the gate current and

switching speed.