| 전자부품 데이터시트 검색엔진 |
|
TLE7250LE 데이터시트(PDF) 12 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
TLE7250LE 데이터시트(HTML) 12 Page - Infineon Technologies AG |
|
12 / 34 page ![]() TLE7250LE TLE7250SJ Functional Description Data Sheet 12 Rev. 1.0, 2015-08-12 4.3.1 Power-down State Independent of the NEN and NRM input pins the TLE7250 is in power-down state when the transmitter supply voltage V CC is turned off (see Figure 5). In the power-down state the input resistors of the receiver are disconnected from the bus biasing V CC/2. The CANH and CANL bus interface of the TLE7250 is floating and acts as a high-impedance input with a very small leakage current. The high-ohmic input does not influence the “recessive” level of the CAN network and allows an optimized EME performance of the entire HS CAN network (see also Table 2). 4.3.2 Power-up The HS CAN transceiver TLE7250 powers up if the transmitter supply V CC is connected to the device. By default the device powers up in power-save mode, due to the internal pull-up resistor on the NEN pin to V CC. In case the device needs to power-up to normal-operating mode, the NEN pin needs to be pulled active to logical “low” while the NRM pin is logical “high” (see Figure 5). |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |