STMPE1601 datasheet(12/58 Pages) STMICROELECTRONICS

12 / 58 page

I2C interface

STMPE1601

12/58

I2C interface

The features that are supported by the I2C interface are listed below:

●

I2C slave device

●

Operates at 1.8 V

●

Compliant to Philips I2C specification version 2.1

●

Supports standard (up to 100kbps) and fast (up to 400 kbps) modes

●

7-bit and 10-bit device addressing modes

●

General Call

●

Start/Restart/Stop

●

Address up to 8 STMPE1601 devices via the I2C interface

The address is selected by the state of 3 pins. The state of the pins is read upon reset and

then the pins can be configured for normal operation. The pins have a pull-up or down to set

the address. The I2C interface module allows the connected host system to access the

registers in the STMPE1601.

6.1

Start condition

A Start condition is identified by a falling edge of SDATA while SCLK is stable at high state.

A Start condition must precede any data/command transfer. The device continuously

monitors for a Start condition and does not respond to any transaction unless one is

encountered.

6.2

Stop condition

A Stop condition is identified by a rising edge of SDATA while SCLK is stable at high state.

A Stop condition terminates the communication between the slave device and bus master. A

read command that is followed by NoAck can be followed by a Stop condition to force the

slave device into idle mode. When the slave device is in idle mode, it is ready to receive the

next I2C transaction. A Stop condition at the end of a write command stops the write

operation to the registers.

Table 12.

I2C addresses

Address

000

40h

001

41h

010

42h

011

43h

100

44h

101

45h

110

46h

111

47h

STMPE1601 데이터시트(PDF) 12 Page - STMicroelectronics

STMPE1601 데이터시트(HTML) 12 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

데이터시트 다운로드

링크 URL