M41T93RMY6F datasheet(34/56 Pages) STMICROELECTRONICS

34 / 56 page

Clock operation

M41T93

34/56

DocID12615 Rev 8

3.8.2

Timer flag (TF)

At the end of a timer countdown, when the timer reloads, TF is set to logic 1. Regardless of

the state of TF bit (or TI/TP bit), the timer will continue decrementing and reloading.

If both timer and alarm interrupts are used in the application, the source of the interrupt can

be determined by reading the flag bits. Refer to Section 3.14 for more information on the

interaction of these bits. The TF bit is cleared by reading the flags register. This will de-

assert an interrupt output due to the timer.

3.8.3

Timer interrupt enable (TIE)

In normal interrupt mode (TI/TP = 0), when TF is asserted, the interrupt output is asserted (if

TIE = 1). To de-assert the interrupt, the TF bit or the TIE bit must be reset. Disabling the

interrupt by clearing the TIE bit will de-assert the output, but does not clear the TF bit. Thus,

if TIE is re-enabled prior to clearing TF, the interrupt will assert immediately.

3.8.4

Timer enable (TE)



TE = 0

When TE = 0, or when the timer register (10h) is set to 0, the timer is disabled.



TE = 1

The timer is enabled. TE is reset (disabled) on power-down. When re-enabled, the

counter will begin counting from the same value as when it was disabled.

3.8.5

TD1/0

These are the timer source clock frequency selection bits (see Table 9). These bits

determine the source clock for the countdown timer (see Table 7). When not in use, the TD1

and TD0 bits should be set to 11 (1/60 Hz) for power saving.

Note:

Writing to the timer register will not reset the TF bit nor clear the interrupt.

Table 9. Timer source clock frequency selection (244.1 μs to 4.25 hrs)

TD1

TD0

Timer source clock frequency (Hz)

4096 (244.1 μs)

64 (15.6 ms)

1 (1 s)

1/60 (60 s)

M41T93RMY6F 데이터시트(PDF) 34 Page - STMicroelectronics

M41T93RMY6F 데이터시트(HTML) 34 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

데이터시트 다운로드

링크 URL