S 1 0 0 0 0 0 0 0

1 0 1 1 1 0 1 0

P

I2C address +write

Soft Reset

Figure 17 soft reset – the gray part consists of AHT10 control.。

6 Signal conversion

6.1 Relative humidity conversion

Relative humidity RH Can be based on SDA

Output relative humidity signal S RH Calculated

by the following formula (the result is %RH

indicates).

6.2 Temperature conversion

Temperature T Can output the signal by the

temperature S T Substitute into the formula below

to calculate (Results are expressed in temperature

°C ):

7 Environmental stability

If the sensor is used in equipment or

machinery, make sure that the sensor used

for the measurement and the sensor used for

the reference perceive the same conditions of

temperature and humidity. If the sensor is

placed in the equipment, the reaction time

will be extended, so it is necessary to ensure

sufficient measurement time in the

programming. The AHT10 sensor is tested

according to the AOSONG temperature

sensor. The performance of the sensor under

other test conditions is not guaranteed and

cannot be used as part of the sensor's

performance. In particular, no commitment is

made to the specific circumstances requested

by the user.