 |
전자부품 데이터시트 검색엔진 |
|
|
전자부품 데이터시트 검색엔진 |
|
WILCS02 데이터시트(PDF) 18 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
WILCS02 데이터시트(HTML) 18 Page - Microchip Technology |
|
|
18 / 71 page  WILCS02IC and WILCS02 Family Device Overview Data Sheet © 2024-2025 Microchip Technology Inc. and its subsidiaries DS70005557C - 18 • A low-impedance ground plane for the WILCS02 Module ensures the best radio performance (best range and lowest noise). The ground plane can be extended beyond the minimum recommendation as required for the host board Electro-Magnetic Compatibility (EMC) and noise reduction. • For the best performance, keep metal structures and components (such as mechanical spacers, bump-on and so on) at least 31.75 mm away from the PCB trace antenna as illustrated in the following figure. • The antenna on the WILCS02 Module must not be placed in direct contact with or in close proximity to plastic casing or objects. Keep a minimum clearance of 10 mm in all directions around the PCB antenna as illustrated in the following figure. Keeping metallic and plastic objects close to the antenna can detune the antenna and reduce the performance of the device. • Exposed GND pads on the bottom of the WILCS02 Module must be soldered to the host board (see the Example of Host Board on Top Layer figure in the WILCS02 Module Routing Guidelines from Related Links). • A PCB cutout or a copper keepout is required under the RF test point (see WILCS02 Module Packaging Information from Related Links). • Copper keepout areas are required on the top layer under voltage test points (see WILCS02 Module Packaging Information from Related Links). • Alternatively, the entire region, except the exposed ground paddle, can be solder-masked. The following figure illustrates the examples of WILCS02 Module placement on a host board with a ground plane. Refer to the following figure for placement-specific guidance. Figure 2-10. Module Placement Guidelines 5.3 mm 15.73 mm Host PCB Ground Plane No Copper Region Edge of Host PCB Ground Plane Module PCB Edge 31.75 mm (keepout clearance region) for all metallic and plastic structures around the antenna. Refer to antenna- specific details of the respective antenna. The following figure illustrates the examples of the WILCS02 Module placement on a host board with a ground plane. Refer to Figure 2-10 for placement-specific guidance. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Korean ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
