CY3672
Document #: 38-07409 Rev. *F
Page 2 of 6
Figure 2 is a close-up of the socket and illustrates the correct
orientation for placing the device into the socket. Pin1 should
always be in the lower left corner, as shown in Figure 3.
Software
Setting up the software is just as easy as setting up the
hardware. Download the latest revisions of CyberClocks and
CY3672 programmer software off of our web site at
www.cypress.com. To install CyberClocks, unzip the file, then
simply run the set-up file in the CyberClocks folder. It will
prompt the user for a few questions and then self-installs.[1]
CyberClocks Online, which is a web based software, is
available on-line through user registration. It configures
spread spectrum clock generators, such as CY25100.
To install the CY3672 software, first run SETUP.EXE to install
necessary DLLs to the windows registry. Once this is done,
run CY3672*.EXE to launch.
When the CY3672 programmer is used for the first time, it is
required to be in “TYPE” mode. This mode is set by pushing
the arrow keys on the programmer until you see “TYPE”
displayed on the LCD screen.
Note:
1. Be sure to check for software updates at http://www.cypress.com/support.
Figure 2. CY3672 Programming Kit Set-up
CY3672
Adapter
PC with Parallel Port
Wall
Power Adapter
Parallel Cable
Figure 3. Device Orientation
Korean ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
