Notes:

1. Maximum rated output current is available at maximum rated output voltage and

derates linearly as input voltage is decreased.

2. Output voltage is load dependent. Under light or no-load conditions, reduce the

input voltage so maximum rated output voltage is not exceeded.

3. Specifications after 30 minute warm-up, full load, at 25°C unless otherwise

indicated.

4. Proper thermal management techniques are required to maintain safe case

temperature at maximum power output.

5. Ripple specification for center-tapped units applies to the voltage between the

positive and negative output terminals.

6. Models G40, G50 & G60 do not have internal bleeder resistors on the output.

Provisions must be made externally to discharge the output capacitors.

DC-HVDC CONVERTER

G Series

2

Output

Characteristic

Minimum

Typical

Maximum

Units

Notes & Conditions

Output Voltage

6000

VDC

See Models & Ratings table

Output Current

15

mA

See Models & Ratings table

Output Voltage Tolerance

±3

%

At Max Vout, Full Load

Minimum Load

No minimum load required

Regulation

Unregulated, Output is proportional to Input. Unloaded output voltage is typically 10% higher than unloaded.

Ripple and Noise

0.1

2.0

%

See Models & Ratings table

Response Time

15

msec

0 to Max Vout, Full Load [G01 to G60]

Input

Characteristic

Minimum

Typical

Maximum

Units

Notes & Conditions

Input Voltage

0.7

12

VDC

Input Current, No Load

175

mA

See Models and Ratings Table.

Input Current, Full Load

400

mA

See Models and Ratings Table.

Environmental

Characteristic

Minimum

Typical

Maximum

Units

Notes & Conditions

Operating Temperature

-10

+60

°C

Case temperature

Storage Temperature

-25

+90

°C

Cooling

Natural convection

Humidity

95

%RH

Non-condensing

Characteristic

Minimum

Typical

Maximum

Units

Notes & Conditions

Isolation: Input to Output

3500

V

<±3500 Bias

Switching Frequency

60

190

kHz

Stable frequency over entire output voltage range

Construction

Case material is Diallyl Phthalate (DAP). UL 94 V-0 rated solid vacuum encapsulation

Mean Time Between Failure

2.29

Mhrs

Bellcore TR 332

General