M25P32-VMP6P datasheet(14/53 Pages) NUMONYX

14 / 53 page

Operating features

M25P32

14/53

When Chip Select (S) is High, the device is deselected, but could remain in the Active Power

mode until all internal cycles have completed (Program, Erase, Write Status Register). The

device then goes in to the Standby Power mode. The device consumption drops to ICC1.

The Deep Power-down mode is entered when the specific instruction (the Deep Power-

down (DP) instruction) is executed. The device consumption drops further to ICC2. The

device remains in this mode until another specific instruction (the Release from Deep

Power-down and Read Electronic Signature (RES) instruction) is executed.

While in the Deep Power-down mode, the device ignores all Write, Program and Erase

instructions (see Deep Power-down (DP)) This can be used as an extra software protection

mechanism, when the device is not in active use, to protect the device from inadvertent

Write, Program or Erase instructions.

4.6

Status Register

The Status Register contains a number of status and control bits that can be read or set (as

appropriate) by specific instructions. See Section 6.4: Read Status Register (RDSR) for a

detailed description of the Status Register bits.

4.7

Protection modes

The environments where non-volatile memory devices are used can be very noisy. No SPI

device can operate correctly in the presence of excessive noise. To help combat this, the

M25P32 features the following data protection mechanisms:

●

Power On Reset and an internal timer (tPUW) can provide protection against inadvertent

changes while the power supply is outside the operating specification.

●

Program, Erase and Write Status Register instructions are checked that they consist of

a number of clock pulses that is a multiple of eight, before they are accepted for

execution.

●

All instructions that modify data must be preceded by a Write Enable (WREN)

instruction to set the Write Enable Latch (WEL) bit. This bit is returned to its reset state

by the following events:

–Power-up

–

Write Disable (WRDI) instruction completion

–

Write Status Register (WRSR) instruction completion

–

Page Program (PP) instruction completion

–

Sector Erase (SE) instruction completion

–

Bulk Erase (BE) instruction completion

●

The Block Protect (BP2, BP1, BP0) bits allow part of the memory to be configured as

read-only. This is the Software Protected Mode (SPM).

●

The Write Protect (W/VPP) signal allows the Block Protect (BP2, BP1, BP0) bits and

Status Register Write Disable (SRWD) bit to be protected. This is the Hardware

Protected Mode (HPM).

●

In addition to the low power consumption feature, the Deep Power-down mode offers

extra software protection, as all Write, Program and Erase instructions are ignored.

M25P32-VMP6P 데이터시트(PDF) 14 Page - Numonyx B.V

M25P32-VMP6P 데이터시트(HTML) 14 Page - Numonyx B.V

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

데이터시트 다운로드

링크 URL