AT25DF011 datasheet(41/50 Pages) RENESAS

41 / 50 page

DS-AT25DF011-032 Rev. J

Page 41

2023-11-14

AT25DF011 Datasheet

14. Power-On/Reset State

When power is first applied to the device, or when recovering from a reset condition, the output pin (SO) is in a

high impedance state, and a high-to-low transition on the CSB pin is required to start a valid command. The SPI

mode (Mode 3 or Mode 0) is automatically selected on every falling edge of CSB by sampling the inactive clock

state.

14.1 Power-Up/Power-Down Voltage and Timing Requirements

During power-up, the device must not be READ for at least the minimum tVCSL time after the supply voltage

reaches the minimum VPOR level (VPOR min). While the device is being powered-up, the internal Power-On Reset

(POR) circuitry keeps the device in a reset mode until the supply voltage rises above the minimum Vcc. During this

time, all operations are disabled, and the device does not respond to any commands.

If the first operation to the device after power-up is a program or erase operation, then the operation cannot be

started until the supply voltage reaches the minimum VCC level and an internal device delay has elapsed. This

delay is a maximum time of tPUW. After the tPUW time, the device is in the standby mode if CSB is at logic high or

active mode if CSB is at logic low. For the case of Power-down then Power-up operation, or if a power interruption

occurs (such that VCC drops below VPOR max), the Vcc of the Flash device must be maintained below VPWD for at

least the minimum specified TPWD time. This is to ensure the Flash device resets properly after a power

interruption.

Table 12. Voltage and Timing Requirements for Power-Up/Power-Down

Figure 30. Power-Up Timing

Symbol

Parameter

Min

Max

Units

VPWD[*]

Not 100% tested (value guaranteed by design and characterization).

VCC for device initialization

1.0

tPWD(1)

Minimum duration for device initialization

300

µs

tVCSL

Minimum VCC to chip select low time for Read command

µs

tVR(1)

VCC rise time

500000

µs/V

VPOR

Power on reset voltage

1.45

1.6

tPUW

Power up delay time before Program or Erase is allowed

CC max

Max V

PWD

Time

PWD

PUW

Full Operation Permitted

VCSL

Read Operation

Permitted

AT25DF011 데이터시트(PDF) 41 Page - Renesas Technology Corp

AT25DF011 데이터시트(HTML) 41 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

데이터시트 다운로드

링크 URL