M48T201V datasheet(23/33 Pages) STMICROELECTRONICS

23 / 33 page

23/33

M48T201Y, M48T201V

VCC Noise And Negative Going Transients

ICC transients, including those produced by output

switching, can produce voltage fluctuations, re-

sulting in spikes on the VCC bus. These transients

can be reduced if capacitors are used to store en-

ergy which stabilizes the VCC bus. The energy

stored in the bypass capacitors will be released as

low going spikes are generated or energy will be

absorbed when overshoots occur. A ceramic by-

pass capacitor value of 0.1µF (as shown in Figure

13) is recommended in order to provide the need-

ed filtering.

In addition to transients that are caused by normal

SRAM operation, power cycling can generate neg-

ative voltage spikes on VCC that drive it to values

below VSS by as much as one volt. These negative

spikes can cause data corruption in the SRAM

while in battery backup mode. To protect from

these voltage spikes, STMicroelectronics recom-

mends connecting a schottky diode from VCC to

VSS (cathode connected to VCC, anode to VSS).

Schottky diode 1N5817 is recommended for

through hole and MBRS120T3 is recommended

for surface mount.

Figure 13. Supply Voltage Protection

AI00605

VCC

0.1

µF

DEVICE

VCC

VSS

M48T201V 데이터시트(PDF) 23 Page - STMicroelectronics