M28C64-12MS3T datasheet(4/24 Pages) STMICROELECTRONICS

4 / 24 page

M28C64

4/24

Table 3. Operating Modes 1

Note: 1. 0=

VIL;1=VIH;X = VIH or VIL; V=12V ± 5%.

Mode

DQ0-DQ7

Stand-by

Hi-Z

Output Disable

Hi-Z

Write Disable

Hi-Z

Read

Data Out

Write

Data In

Chip Erase

Hi-Z

SIGNAL DESCRIPTION

The external connections to the device are

summarized in Table 1, and their use in Table 3.

Addresses (A0-A12). The address inputs are

used to select one byte from the memory array

during a read or write operation.

Data In/Out (DQ0-DQ7). The contents of the data

byte are written to, or read from, the memory array

through the Data I/O pins.

Chip Enable (E). The chip enable input must be

held low to enable read and write operations.

When Chip Enable is high, power consumption is

reduced.

Output Enable (G). The Output Enable input

controls the data output buffers, and is used to

initiate read operations.

Write Enable (W). The Write Enable input controls

whether the addressed location is to be read, from

or written to.

Ready/Busy (RB). Ready/Busy is an open drain

output that can be used to detect the end of the

internal write cycle.

DEVICE OPERATION

In order to prevent data corruption and inadvertent

write operations, an internal VCC comparator

inhibits the Write operations if the VCC voltage is

lower than VWI (see Table 4A and Table 4B). Once

the voltage applied on the VCC pin goes over the

VWI threshold (VCC>VWI), write access to the

memory is allowed after a time-out tPUW,as

specified in Table 4A and Table 4B.

Further protection against data corruption is

offered by the E and W low pass filters: any glitch,

on the E and W inputs, with a pulse width less than

10 ns (typical) is internally filtered out to prevent

inadvertent write operations to the memory.

Table 4A. Power-Up Timing1 for M28C64 (5V range)

(TA = 0 to 70 °C or –40 to 85 °C or –40 to 125 °C; VCC = 4.5 to 5.5 V)

Note: 1. Sampled only, not 100% tested.

Table 4B. Power-Up Timing1 for M28C64-xxW (3V range)

(TA = 0 to 70 °C or –40 to 85 °C; VCC = 2.7 to 3.6 V)

Note: 1. Sampled only, not 100% tested.

Symbol

Parameter

Min.

Max.

Unit

tPUR

Time Delay to Read Operation

µs

tPUW

Time Delay to Write Operation (once VCC

≥ VWI)10

VWI

Write Inhibit Threshold

3.0

4.2

Symbol

Parameter

Min.

Max.

Unit

tPUR

Time Delay to Read Operation

µs

tPUW

Time Delay to Write Operation (once VCC

≥ VWI)15

VWI

Write Inhibit Threshold

1.5

2.5

M28C64-12MS3T 데이터시트(PDF) 4 Page - STMicroelectronics

M28C64-12MS3T 데이터시트(HTML) 4 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

데이터시트 다운로드

링크 URL