9

MAINTENANCE

REPLACING NOZZLE

After 10-12 hours of blasting time the nozzle should be checked for wear. The

nozzle will wear out overtime and should be replaced when the hole is no longer

round or the abrasive media does not flow smoothly through it.To replace the

nozzle:

1. Disconnect the sandblasting gun from the air hose.

2.

Nozzle

Unscrew the nozzle adapter,

located at the front of the

sandblasting gun.

3. Remove the old nozzle.

4. Insert new nozzle.

5. Replace the nozzle adapter and

firmly screw it onto sandblasting

gun.

• Keep your sandblaster clean,

and protect it from damage.

• Check for worn abrasive hose and fittings. Watch for leaks, blistering,

bulging or thinning of the hose.

• Replace any parts which appear worn.

PARTS AND SERVICING

For Parts & Servicing, please contact your nearest dealer, or

CLARKE International, on one of the following numbers.

PARTS & SERVICE TEL: 020 8988 7400

PARTS & SERVICE FAX: 020 8558 3622

or e-mail as follows:

PARTS: Parts@clarkeinternational.com

SERVICE: Service@clarkeinternational.com