11

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DAILY CARE

Always ensure the cables & clamps are in good condition and the clamps are

clean and corrosion free. If damaged they should be replaced. Keep the unit

clean by wiping with a dry cloth. DO NOT use solvents as a cleaning agent.

Keep the unit fully charged at all times.

Always turn the jumpstarter OFF during storage and store in an upright position,

away from direct sunlight, moisture or sources of extreme heat or cold.

NEVER attempt any repair unless your are a qualified technician. Your CLARKE

jumpstarter has been designed to give long and trouble free service. If,

however, having followed the instructions in this booklet carefully, you

encounter problems, take the unit to your local CLARKE dealer.

Q&A / TROUBLESHOOTING

Question

Answer

Why didn’t my

Jumpstarter start my

vehicle?

There could be a number of reasons why the

Jumpstarter didn’t start your vehicle.

a) Ensure the Jumpstarter battery is fully charged

b) Ensure you have followed the correct operat-

ing procedures and the clamps are well con-

nected.

c) Ensure the vehicle operates on 12V DC or 24V

DC.

d) When the car battery voltage is less than 2.5V,

ensure that the clamps are well connected,

then press the On/Off button for 5 seconds, the

device will detect the connection with a warn-

ing sound, when pressed for 10 seconds the

device will be activated for starting.

e) Ensure the vehicle is not over 10 litres in size.

How do I turn off the

jumpstarter?

The jumpstarter has intelligent detection function. If

there is no load, or the starter is charged for a long

time, it will automatically fall into ‘sleep mode’ and

save the energy.

How long do I have to

charge the

jumpstarter for?

Usually 6 - 8 hours. It will automatically stop charging

after the starter is fully charged.