6

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CHARGING THE DEVICE

CHARGING

You can charge the jumpstarter using:

• The 12V DC USB car adapter.

• A device with a USB output socket.

1. Plug the USB-C charging cable into the

jumpstarter PD60W input port and the other end

in to a suitable car adapter socket, or into any

other suitable power source.

• If you are using a car adapter socket it is

recommended that you start the engine.

• If no suitable USB-C power socket or power

source is available a USB-A to USB-C cable (not

supplied) can be used instead.

2. Disconnect the charger when fully charged.

TO GET THE MAXIMUM LIFE FROM THE BATTERY

• Charge the jumpstarter before first use.

• Charge the jumpstarter at least every 3 months and after each use

• DO NOT leave in a state of discharge.

OPERATION

WORKLIGHT

1. Press and hold the POWER button for

2 seconds to turn the jumpstarter on.

2. Then double press the POWER

button to turn the worklight on.

3. Press the POWER button again to put

the worklight into a Morse code S-O-S pattern.

4. Press the POWER button again to put the worklight into a fast flashing pattern.

5. Press the POWER button again to turn the worklight off.