7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

USING THE MAINS CHARGER

1. Plug the charger into a mains power outlet.

2. Insert the charging connector into the Charging Input socket on the jump starter

control panel.

• The digital display will show “CHARGING BATTERY” and a reading of the

battery's percent of charge will be displayed.

• The display will show “100%” once the internal battery is fully charged.

3. When charging is complete, unplug the charger and disconnect it from the jump

starter.

4. Recharge the jump-start battery after every use if possible, or at least every 90

days.

5. Always avoid leaving your jump-start in a discharged state.

• Charging could take several hours, dependant upon the state of charge.

Keep the battery charged to ensure maximum life from the battery.

RUNNING/CHARGING USB DEVICES

The jump starter has two standard USB

ports providing up to 2A at 5V DC.

1. Press the Power Button.

• The screen will show the battery

level and “USB 12V ON”.

2. Plug the USB connector into the USB

output port on the front panel of the

jump starter.

3. Plug the appropriate connector on

the USB cable into the device.

4. Turn your device on if necessary.

5. When finished using, turn off your device and unplug it from the USB cable.

RUNNING/CHARGING DC APPLIANCES

The standard auxiliary outlet socket provides a continuous 12V DC output, at a

maximum of 10 Amps to power 12V DC devices such as tyre inflators, coolers etc.

1. Verify the jumpstarter is fully charged. Recharge if needed.

2. Make sure the appliance to be powered is turned off and its power requirements do

not exceed 10A.

3. Plug the appliance into the 12V auxillary outlet socket.

4. Turn on the appliance.