UPC835

R03DS0186EJ0100 Rev.1.00

Page 2 of 8

Mar.10.25

EQUIVALENT CIRCUIT (1/2 Circuit)

PIN CONFIGURATION (Top View)

ABSOLUTE MAXIMUM RATINGS (TA = 25 °C, unless otherwise specified)

Parameter

Symbol

UPC835

Unit

Supply Voltage Note1

V+ - V-

-0.3 ~ +36

V

Differential Input Voltage

VID

±30

V

Input Voltage Note 2

VI

V- -0.3 ~ V+ +0.3

V

Output Applied Voltage Note3

VO

V- -0.3 ~ V+ +0.3

V

Total Power Dissipation Note4

PT

350

mW

Output Short Circuit Duration Note5

Indefinite

s

Operating Ambient Temperature

TA

-40 ~ +85

°C

Storage Temperature

Tstg

-55 ~ +125

°C

【

Notes】 1. Note that reverse connections of the power supply may damage the ICs.

2. The input terminal must be applied within the input voltage range to avoid deteriorating or damaging the

device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The Op-

Amp input voltage must operates within the electrical characteristics range of input common-mode voltage.

3. The output terminal must be applied within the output voltage range to avoid deteriorating or damaging the

device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The Op-

Amp output voltage must operates within the electrical characteristics range of maximum output voltage.

4. This is the value when TA ≤ 59°C during loading a glass epoxy substrate (size: 100 mm x 100 mm,thickness:

1 mm, filling wiring of 15% of the substrate only on the one side of copper foil). When TA > 59°C,conduct a

derating in −5.4 mW/°C. The heat resistance between a junction and ambient air under the same condition is

Rth(J-A) = 187°C /W.

5. Pay careful attention to the total power dissipation not to exceed the absolute maximum ratings, Note 4.

Caution Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any parameter.

That is, the absolute maximum ratings are rated values at which the product is on the verge of suffering physical

damage, and therefore the product must be used under conditions that ensure that the absolute maximum

ratings are not exceeded.

RECOMMENDED OPERATING CONDITIONS

Parameter

Symbol

MIN.

TYP.

MAX.

Unit

Power Supply Voltage

V±

±5

±16

V

Output Current

IO

±6

mA

Load Capacitance

(When AV = +1)

CL

4000 Note6

pF

【

Note】6. This is the value when the feedback resistor (Rf) = 0 Ω. The higher the Rf value, the more likely it is to oscillate

due to the influence of the input capacitance. So connect a capacitor of about 100 pF in parallel with Rf.