5

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

operation. If damaged, have the power tool repaired before use. Many

accidents are caused by poorly maintained power tools.

6. Keep cutting tools sharp and clean. Sharp cutting edges are less likely to

bind and are easier to control.

7. Use the power tool, accessories and tool bits etc. in accordance with these

instructions, taking into account the working conditions and the work to be

performed. Use of the power tool for operations different from those

intended could result in a hazardous situation.

SERVICE

1. Have your power tool serviced by a qualified repair person using only

identical replacement parts. This will ensure that the safety of the power

tool is maintained.

PLANER SAFETY WARNINGS

1. Wait for the blade to stop before setting the planer down. An exposed

rotating blade can strike the worktop, leading to possible loss of control

and injury.

2. Hold the planer by insulated gripping surfaces, because the blade may

contact its own cable. Cutting a “live” wire may make exposed metal parts

of the planer “live” and could give the operator an electric shock.

3. Use clamps or another practical way to secure and support the workpiece

to a stable platform. Holding the workpiece by your hand or against the

body leaves it unstable and can lead to loss of control.

4. Always start the planer before the blade is in contact with the workpiece

and let the blade reach full speed. The tool can vibrate or chatter if blade

speed is too slow at beginning of the cut and possibly kickback.

5. Check the workpiece for nails or screws. If there are nails/screws, either

remove or set them well below intended finished surface. Kickback,

damage to the blades and personal injury can result If the planer blades

strike objects like nails.

6. Unplug the planer before changing accessories. Before plugging the

planer in, check that the trigger lock is “OFF”. Accidental start-ups can

occur if the planer is plugged in while changing an accessory.

7. After changing blades, rotate the blade drum to make sure the blades are

not hitting any part of the housing and that the blade locking screws are

tight. Spinning blades could strike the tool housing and damage the tool as

well as causing possible injury.

8. Always hold the planer firmly with both hands for maximum control.