8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

OPERATION

FITTING THE SANDING SHEET

With the sander disconnected from the power supply, select the sanding

sheet appropriate for the task and attach it to the base plate as follows. Either

plain sanding sheets or prepared sheets for hook and loop attachment can

be used.

PAPER SANDING SHEETS

1. Lift the retaining clips to the open

position and insert one end of the

sanding sheets under the

retaining clip.

2. Set the clip back in the retaining

position to hold the sheet and

lightly stretch it over the

baseplate, ensuring it is not folded

or wrinkled, then position it under

the other retaining clip.

3. Lock the second clip back into the retaining position.

4. Check the paper lays straight and

flat on the baseplate. If not,

release either clip and adjust the

sheet before resetting the clip.

HOOK AND LOOP SANDING SHEETS

1. Align the sanding sheet so that

the holes align with those in the

baseplate, press the sheet evenly

onto the base plate to attach it.

REPLACEMENT SHEETS

The following sanding sheets are available from your CLARKE dealer.

Grit

Size (mm)

Part No

60

93 x 287 mm

6502075

120

93 x 287 mm

6502076

240

93 x 287 mm

6502077