AS7263 datasheet(15/46 Pages) AMSOSRAM

15 / 46 page

Page 14

Datasheet, Public

Document Feedback

[v4-00] 2022-Nov-30

AS7263 − Detailed Description

Data Conversion Description

AS7263 spectral conversion is implemented via two

photodiode banks per device. Bank 1 consists of data from the

S, T, U, V photodiodes. Bank 2 consists of data from the R, T, U,

W photodiodes. Spectral conversion requires the integration

time (IT in ms) set to complete. If both photodiode banks are

required to complete the conversion, the 2nd bank requires an

additional IT ms. Minimum IT for a single bank conversion is 2.8

ms. If data is required from all 6 photodiodes then the device

must perform 2 full conversions (2 x Integration Time).

The spectral conversion process is controlled with BANK Mode

settings as follows:

BANK Mode 0: Data will be available in registers S, T, U & V (R

and W registers will be zero).

BANK Mode 1: Data will be available in registers R, T, U & W (V

and W registers will be zero).

BANK Mode 2: Data will be available in registers R, S, T, U, V & W

When the bank setting is Mode 0, Mode 1, or Mode 2, the

spectral data conversion process operates continuously, with

new data available after each IT ms period. In the continuous

modes, care should be taken to assure prompt interrupt

servicing so that integration values from both banks are all

derived from the same spectral conversion cycle.

BANK Mode 3: Data will be available in registers R, S, T, U, V & W

in One-Shot mode.

When the bank setting is Mode 3, the device operates in

One-Shot mode. Spectral conversion occurs only when bit 0 of

the control register (1SHOT ) is set to 1. The 1SHOT bit in the

control register is subsequently cleared by hardware at the

same time the DATA_RDY bit is set to 1 indicating the availability

of spectral conversion result data. The One-Shot mode is

intended for use when it is critical to ensure that spectral

conversion results are obtained contemporaneously.

AS7263 데이터시트(PDF) 15 Page - ams-OSRAM AG