 |
전자부품 데이터시트 검색엔진 |
|
|
전자부품 데이터시트 검색엔진 |
|
CMV20000 데이터시트(PDF) 25 Page - ams-OSRAM AG |
|
|
|||||||||||||||||||||||||||||
CMV20000 데이터시트(HTML) 25 Page - ams-OSRAM AG |
|
|
25 / 69 page  CMV20000 Functional description Datasheet • PUBLIC • Document Feedback DS000440 • v3-00 • 2026-Mar-13 25 / 69 / 7.2.3 Reset sequence If a sensor reset is necessary while the sensor is running, the following sequence should be followed. Figure 8: Reset sequence The on-board sequencer will be reset and all programming registers will return to their default start-up values when a falling edge is detected on the SYS_RES_N pin. After the reset there is a minimum time of 1 μs needed before a FRAME_REQ pulse can be sent. All recommended register settings must be reloaded after a reset sequence. 7.2.4 SPI programming Programming the sensor is done by writing the appropriate values to the on-board registers. These registers can be written over a simple serial interface (SPI). The details of the timing and data format are described below. The data written to the programming registers can also be read out over this same SPI interface. The SPI out does not have a tri-state, so multiple SPI outputs cannot be on the same bus without a buffer. 1μs CLK_IN SYS_RES_N FRAME_REQ |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Korean ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
