3

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

2. At each of the rear mountings,

attach a leg, with the foot pad

downwards using two M8 bolts with

each leg, ensuring a flat washer is

used with the nut. Nip up the nuts -

DO NOT fully tighten.

3. Attach the front legs in a similar

manner using M8 bolts with nuts

and flat washers. DO NOT fully

tighten.

4. Position the shelf between the legs,

using an assistant, and bolt it to the

legs, using M8 bolts with nuts and

flat washers. DO NOT fully tighten

the nuts. NOTE The tray will only fit

one way round.

5. Finally, turn the workbench on to its

feet on a flat, even surface and

shake it vigorously to ensure it is

completely stable and resting

evenly on all four legs, then fully

tighten all nuts.

6. Slot the single drawer into place in

the ball bearing draw runners.

7. If a CD3WB 3-drawer unit is

purchased, this can be slotted into

place on the spare runners.