8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CHECKING/FILLING THE ENGINE OIL BEFORE USE

NOTE: The pump will normally be shipped without oil in the engine and will

require filling before use.

1. Turn the oil filler cap anti-clockwise

and remove from the oil fill tube.

2. Clean the dipstick with a clean cloth.

3. Put the dipstick into the oil fill tube

and then remove it again. DO NOT

screw in the oil filler cap/dipstick

when doing this.

4. If the oil level is at or below the ‘L’

mark on the dipstick, add oil to the

crankcase.

• Fill until the oil touches the

threads in the oil fill tube.

• Oil capacity (See page 20).

• We recommend that you use

CLARKE SAE10W30 oil (Part No:

3050845) in this pump available

from your CLARKE dealer.

5. Replace the oil filler cap.

WARNING: TO DO THIS CHECK, PUT THE PUMP ON LEVEL GROUND

WITH THE ENGINE SWITCHED OFF.

WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS OF THE

PUMP WHEN CHECKING THE OIL LEVEL.