16

A22E

Assembling the Cap

Installing/Replacing the Lamp

Control Box (Enclosure)

Emergency Stop Switch

• Insert the protrusion of the Tightening Wrench (A22Z-3905) into the Cap slot and then turn to remove the Cap.

Cap slot Protrusion

(1) Installing/Replacing from the Panel Surface

(2) Installing/Replacing on the Switch

• Insert the Lamp Extractor (A22Z-3901) into the lamp, then rotate the Extractor

while pressing it.

• Grip the indicator with your fingers, then rotate the indicator while pressing it

against the Switch.

(1) Mounting the Switch

(2) Creating a Cable Port Hole

(3) Securing the Connector Cable

The Standard-size Legend Plate Frame can

be mounted.

Mount the Frame as shown in the following

diagram. Mount the Switch in the same way

as for an ordinary panel.

Place the tip of a screwdriver on the surface

where the cable port hole is to be created

with the cover attached and strike the

screwdriver to punch a hole.

Attempts to punch a hole on the other side

of the case will damage the Box.

1. Insert the connector into the cable port hole in the Box and secure

with the Mounting Ring inside the box.

2. Pass the tightening cap through the cable, insert the cable into the

connector, and tighten the tightening cap to secure the cable.

Snap-in Legend Plate

Mounting

RIng

Rubber washer

Connector

Outside

Inside

Box

Cable

Tightening cap

Cable diameter

Connector

7 to 9 dia.

A22Z-3500-1

9 to 11 dia.

A22Z-3500-2