G-318

Safety Sensors / Components

Assembling the Cap

Emergency Stop Switch

Insert the protrusion of the Tightening Wrench (A22Z-3905) into the

Cap slot and then turn to remove the Cap.

Installing/Replacing the Lamp

Installing/Replacing from the Panel Surface

Insert the Lamp Extractor (A22Z-3901) into the lamp, then rotate the

Extractor while pressing it.

Installing/Replacing on the Switch

Grip the indicator with your fingers, then rotate the indicator while

pressing it against the Switch.

Control Box (Enclosure)

Mounting the Switch

The Standard-size Legend Plate Frame can be mounted. Mount the

Frame as shown in the following diagram. Mount the Switch in the

same way as for an ordinary panel.

Creating a Cable Port Hole

Place the tip of a screwdriver on the surface where the cable port

hole is to be created with the cover attached and strike the screw-

driver to punch a hole. Attempts to punch a hole on the other side of

the case will damage the Box.

Securing the Connector Cable

1. Insert the connector into the cable port hole in the Box and secure

with the fixing nut inside the box.

2. Open a hole in the thin rubber section of the rubber ring.

3. Pass the tightening cap through the cable, insert the cable into

the connector, and tighten the hexagonal nut to secure the cable.

Cable diameter

Connector

7 to 9 dia.

A22Z-3500-1

9 to 11 dia.

A22Z-3500-2

Snap-in Legend Plate

Lock nut

Rubber washer

Connector

Tightening cap

Inside

Outside

Box

Cable