D4N

19

Recommended Connectors

Use connectors with screws not exceeding 9 mm, otherwise the

screws will protrude into the case interior, interfering with other

components in the case.

The connectors listed in the following table have connectors with

thread sections not exceeding 9 mm.

Use the recommended connectors to ensure conformance to IP67.

Use LAPP connectors together with seal packing (JPK-16, GP-13.5,

or GPM20), and tighten to the specified tightening torque. Seal

packing is sold separately.

• LAPP is a German manufacturer.

Others

• When attaching a cover, be sure that the seal rubber is in place and

that there is no foreign material present. If the cover is attached

with the seal rubber out of place or if foreign material is stuck to the

rubber, a proper seal will not be obtained.

• Do not use any screws to connect the cover other than the

specified ones. The seal characteristics may be reduced.

• Make sure that foreign particles do not enter the head when

removing the screws from the four corners to change the head

position in any of the four directions.

• Use the following recommended countermeasures to prevent

telegraphing when using adjustable or long levers.

1. Make the rear edge of the dog smooth with an angle of 15

° to

30

° or make it in the shape of a quadratic curve.

2. Design the circuit so that no error signal will be generated.

Size

Manufacturer

Model

Applicable cable

diameter

G1/2

LAPP

ST-PF1/2

5380-1002

6.0 to 12.0 mm

Pg13.5

LAPP

ST-13.5

5301-5030

6.0 to 12.0 mm

M20

LAPP

ST-M20

× 1.5

5311-1020

7.0 to 13.0 mm