PIC24FJ64GA006 datasheet(5/10 Pages) MICROCHIP

5 / 10 page

DS80330A-page 5

PIC24FJ128GA010

22. Module: I2C™

During I2C Slave mode transactions, the Data/

Address bit, D/A, may not update during the data

frame. This affects both 7 and 10-Bit Addressing

modes.

I2C slave receptions are not affected by this issue.

Work around

Use the Read/Write bit, R/W, and the Transmit

Buffer Full Status Bit, TBF, to determine whether

address or data information is being received.

For more information, see Figure 24-30 and

Figure 24-31 in “Section 24. Inter-Integrated

Circuit™ (I2C™)” (DS39702A).

Date Codes that pertain to this issue:

All engineering and production devices.

23. Module: I2C

When the I2C module is operating in Slave mode,

after the ACKSTAT bit is set when receiving a

NACK from the master, it may be cleared by the

reception of a Start or Stop bit.

Work around

Store the value of the ACKSTAT bit immediately

after receiving a NACK from the master.

Date Codes that pertain to this issue:

All engineering and production devices.

24. Module: UART

When an auto-baud is detected, the receive inter-

rupt may occur twice. The first interrupt occurs at

the beginning of the Start bit and the second after

reception of the Sync field character.

Work around

If a receive interrupt occurs, check the URXDA bit

(UxSTA<0>) to ensure that valid data is available.

On the first interrupt, no data will be present. The

second interrupt will have the Sync field character

(55h) in the receive FIFO.

Date Codes that pertain to this issue:

All engineering and production devices.

25. Module: UART

The auto-baud may miscalculate for certain baud

rates and clock speed combinations, resulting in a

BRG value that is 1 greater or less than the

expected value. When UxBRG is less than 50, this

can result in transmission and reception failures

due to introducing error greater than 1%.

Work around

Test auto-baud calculations at various clock speed

and baud rate combinations that would be used in

applications. If an inaccurate UxBRG value is

generated, manually correct the baud rate in user

code.

Date Codes that pertain to this issue:

All engineering and production devices.

26. Module: UART

When the UART is in 4x mode (BRGH = 1) and

using two Stop bits (STSEL = 1), it may sample the

first Stop bit instead of the second one.

This issue does not affect the other UART

configurations.

Work around

Use the 16x baud rate option (BRGH = 0) and

adjust the baud rate accordingly.

Date Codes that pertain to this issue:

All engineering and production devices.

27. Module: SPI

In SPI Master mode, the Disable SCK Pin bit,

DISSCK, may not disable the SPI clock. As a

result, the PIC® microcontroller must provide the

SPI clock in Master mode.

Work around

None.

Date Codes that pertain to this issue:

All engineering and production devices.

PIC24FJ64GA006 데이터시트(PDF) 5 Page - Microchip Technology

PIC24FJ64GA006 데이터시트(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10

데이터시트 다운로드

링크 URL