PSD501B1 datasheet(92/153 Pages) STMICROELECTRONICS

92 / 153 page

PSD5XX Family

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

****

FrezAck3

FrezAck2

FrezAck1

FrezAck0

NOTES: At RESET all these bits intialize as 0's.

* = Not used.

9.6.2.6 Status Flags Register

There are eight READ-ONLY status flags. The lower four bits represent Freeze

Acknowledge bits.

Counter/Timer

Registers

(Cont.)

FrezAck Bits

These Freeze Acknowledge bits are useful in the Freeze/Freeze Acknowledge protocol.

After the Microcontroller senses that the FrezAck bit is being set it proceeds to access the

Image Register for a read or write operation.

FrezAck0 Bit:

When this bit is

Image Register Access is granted.

Image Register Access is not granted.

FrezAck1 Bit:

When this bit is

Image Register Access is granted.

Image Register Access is not granted.

FrezAck2 Bit:

When this bit is

Image Register Access is granted.

Image Register Access is not granted.

FrezAck3 Bit:

When this bit is

Image Register Access is granted.

Image Register Access is not granted.

DLCY Register:

Bits

<4:0> of the DLCY register are used to assign Delay Cycles to the Counter/Timer.

Various Clock Scaling values possible are 0 through 31 (decimal).

At RESET these bits initialize as 0. If necessary, the user has the option to set these bits up

to generate Delay Cycles (DLCY) to scale down the Counter/Timer clock (see Table 24).

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

DLCY4

DLCY3

DLCY2

DLCY1

DLCY0

NOTE: * = Not used.

PSD501B1 데이터시트(PDF) 92 Page - STMicroelectronics

PSD501B1 데이터시트(HTML) 92 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL