ST10F269 datasheet(136/160 Pages) STMICROELECTRONICS

136 / 160 page

ST10F269

136/160

21.4 - AC characteristics

21.4.1 - Test Waveforms

21.4.2 - Definition of Internal Timing

The internal operation of the ST10F269 is

controlled by the internal CPU clock fCPU. Both

edges of the CPU clock can trigger internal (for

example pipeline) or external (for example bus

cycles) operations.

The specification of the external timing (AC

Characteristics) therefore depends on the time

between two consecutive edges of the CPU clock,

called “TCL”.

The CPU clock signal can be generated by

different mechanisms. The duration of TCL and its

variation (and also the derived external timing)

depends on the mechanism used to generate

fCPU.

This influence must be regarded when calculating

the timings for the ST10F269.

The example for PLL operation shown in Figure

67 refers to a PLL factor of 4.

Figure 65 : Input / Output Waveforms

Figure 66 : Float Waveforms

2.4V

0.45V

Test Points

0.2VDD+0.9

0.2VDD-0.1

AC inputs during testing are driven at 2.4V for a logic ‘1’ and 0.4V for a logic ‘0’.

Timing measurements are made at VIH min for a logic ‘1’ and VIL max for a logic ‘0’.

Timing

Reference

Points

VLoad +0.1V

VLoad -0.1V

VOH -0.1V

VOL +0.1V

VLoad

VOL

VOH

For timing purposes a port pin is no longer floating when VLOAD changes of ±100mV.

It begins to float when a 100mV change from the loaded VOH/VOL level occurs (IOH/IOL = 20mA).

ST10F269 데이터시트(PDF) 136 Page - STMicroelectronics

ST10F269 데이터시트(HTML) 136 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL