ST7263 datasheet(74/109 Pages) STMICROELECTRONICS

74 / 109 page

ST7263

74/109

I²C BUS INTERFACE (Cont’d)

The Acknowledge function may be enabled and

disabled by software.

The I²C interface address and/or general call ad-

dress can be selected by software.

The speed of the I²C interface may be selected be-

tween Standard (0-100 kHz) and Fast I²C (100-

400 kHz).

SDA/SCL Line Control

Transmitter mode: the interface holds the clock

line low before transmission to wait for the micro-

controller to write the byte in the Data Register.

Receiver mode: the interface holds the clock line

low after reception to wait for the microcontroller to

read the byte in the Data Register.

The SCL frequency (FSCL) is controlled by a pro-

grammable clock divider which depends on the I²C

bus mode.

When the I²C cell is enabled, the SDA and SCL

ports must be configured as floating open-drain

output or floating input. In this case, the value of

the external pull-up resistor used depends on the

application.

When the I²C cell is disabled, the SDA and SCL

ports revert to being standard I/O port pins.

Figure 39. I²C Interface Block Diagram

DATA REGISTER (DR)

DATA SHIFT REGISTER

COMPARATOR

OWN ADDRESS REGISTER (OAR)

CLOCK CONTROL REGISTER (CCR)

STATUS REGISTER 1 (SR1)

CONTROL REGISTER (CR)

SDAI

SCLI

CONTROL LOGIC

STATUS REGISTER 2 (SR2)

INTERRUPT

CLOCK CONTROL

DATA CONTROL

SCL

SDA

ST7263 데이터시트(PDF) 74 Page - STMicroelectronics

ST7263 데이터시트(HTML) 74 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL