ST7SCR datasheet(66/102 Pages) STMICROELECTRONICS

부품명	ST7SCR

상세설명	8-BIT LOW-POWER, FULL-SPEED USB MCU WITH 16K FLASH, 768 RAM, SMARTCARD I/F, TIMER

PDF	102 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

66 / 102 page

ST7SCR

66/102

SMARTCARD INTERFACE (Cont’d)

CHARACTER WAITING TIME REGISTER (CRD-

WTx)

CRDWT2

Read/Write

Reset Value: 0000 0000 (00h) .

CRDWT1

Read/Write

Reset Value: 0010 0101 (25h)

CRDWT0

Read/Write

Reset Value: 1000 0000 (80h)

WT: Character waiting time value expressed in

ETU (0 / 16777215).

The CRDWT0, CRDWT1 and CRDWT2 registers

hold the load value of the Waiting Time counter.

Note: A read operation does not return the counter

value.

This counter can be used as a general purpose

timer.

If the WTEN bit of the CRDCR register is reset, the

counter is reloaded when a write access in the

CRDWT2 register occurs. It starts when the

WTEN bit is set.

If the WTEN bit in the CRDCR register is set and if

UART mode is activated, the counter acts as an

autoreload timer. The timer is reloaded when a

start bit is sent or detected. An interrupt is generat-

ed if the timer overflows between two consecutive

start bits.

Note: When loaded with a 0 value, the Waiting

Time counter stays at 0 and the WTF bit = 1.

WT9

WT8

WT 7

WT6

WT5

WT4

WT3

WT2

WT1

WT0

ST7SCR 데이터시트(PDF) 66 Page - STMicroelectronics

ST7SCR 데이터시트(HTML) 66 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL