ST95020 datasheet(9/18 Pages) STMICROELECTRONICS

9 / 18 page

Byte Write Operation

Prior to any write attempt, the write enable latch

must be set by issuing the WREN instruction. First

the device is selected (S = low) and a serial WREN

instruction byte is issued. Then the product is de-

selected by taking S high. After the WREN instruc-

tion byte is sent, the Memory will set the write

enable latch and then remain in standby until it is

deselected. Then the write state is entered by

selecting the chip, issuing two bytes of instruction

and address, and one byte of data.

Chip Select (S) must remain low for the entire

duration of the operation. The product must be

deselectedjust after the eighth bit of data has been

latched in. If not, the write process is cancelled. As

soon as the product is deselected, the self-timed

write cycle is initiated. While the write isin progress,

the status register may be read to check BP1, BP0,

WEL and WIP. WIP is high during the self-timed

write cycle. When the cycle is completed, the write

enable latch is reset.

Page Write Operation

A maximum of 16 bytes of data may be written

during one non-volatile write cycle. All 16 bytes

must reside on the same page. The page write

mode is the same as the byte write mode except

that instead of deselecting the device after the first

byte of data, up to 15 additionalbytes can be shifted

in prior to deselecting the chip. A page address

begins with address xxxx 0000 and ends with xxxx

1111. If the address counter reaches xxxx 1111and

the clock continues, the counter will roll over to the

first address of the page (xxxx 0000) and overwrite

any previously written data. The programming cy-

cle will only start if the S transition occurs just after

the eighth bit of data of a word is received.

POWER ON STATE

After a Power up the Memory is in the following

state:

– The device is in the low power standby state.

– The chip is deselected.

– The chip is not in hold condition.

– The write enable latch is reset.

– BP1 and BP0 are unchanged (non-volatile

bits).

AI01445

9 10 111213 1415

HIGH IMPEDANCE

INSTRUCTION

STATUS REG.

Figure 11. WRSR: Write Status Register Sequence

9/18

ST95040, ST95020, ST95010

ST95020 데이터시트(PDF) 9 Page - STMicroelectronics

ST95020 데이터시트(HTML) 9 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

데이터시트 다운로드

링크 URL