ADP121 datasheet(4/20 Pages) AD

4 / 20 page

ADP121

Rev. 0 | Page 4 of 20

Parameter

Symbol

Conditions

Min

Typ

Max

Unit

POWER SUPPLY REJECTION RATIO

PSRR

10 kHz, VIN = 5 V, VOUT = 3.3 V

10 kHz, VIN = 5 V, VOUT = 2.5 V

10 kHz, VIN = 5 V, VOUT = 1.2 V

INPUT AND OUTPUT CAPACITOR5

Minimum Input and Output Capacitance

CAPMIN

TJ = −40°C to +125°C

0.70

μF

Capacitor ESR

RESR

TJ = −40°C to +125°C

0.001

1 Based on an end-point calculation using 1 mA and 100 mA loads. See

for typical load regulation performance for loads less than 1 mA.

Figure 6

2 Dropout voltage is defined as the input-to-output voltage differential when the input voltage is set to the nominal output voltage. This applies only for output

voltages above 2.3 V.

3 Start-up time is defined as the time between the rising edge of EN to VOUT being at 90% of its nominal value.

4 Current-limit threshold is defined as the current at which the output voltage drops to 90% of the specified typical value. For example, the current limit for a 3.0 V

output voltage is defined as the current that causes the output voltage to drop to 90% of 3.0 V, or 2.7 V.

5 The minimum input and output capacitance should be greater than 0.70 μF over the full range of operating conditions. The full range of operating conditions in the

application must be considered during device selection to ensure that the minimum capacitance specification is met. X7R and X5R type capacitors are recommended;

Y5V and Z5U capacitors are not recommended for use with any LDO.

ADP121 데이터시트(PDF) 4 Page - Analog Devices

ADP121 데이터시트(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

데이터시트 다운로드

링크 URL