STMPE1601 datasheet(25/61 Pages) STMICROELECTRONICS

25 / 61 page

STMPE1601

Interrupt system

25/61

9.1.1

Interrupt latency

When the generation of interrupts by the GPIO as input is enabled, the latency (time taken

from actual transition at GPIO to time of INT pin assertion) is shown in the following table:

INT_CTRL

Interrupt control register

Address:

0x10, 0x11

Type:

R, R/W

Reset:

0x00

Description:

The interrupt control register is used to configure the interrupt controller. It has a

global enable interrupt mask bit that controls the interruption to the host.

Table 18.

Interrupt latency

State of operation

Interrupt latency

Hibernation

10 uS max

Sleep

5 uS max

Active

2 uS max

987654

3210

INT_CTRL_msb

INT_CTRL_lsb

Reserved

IC2

IC1

IC0

RRRRRRR

RRRRR

000000

0000

[15:3] RESERVED

[2] IC2: Output Interrupt polarity

‘0’ = Active low/falling edge

‘1’ = Active high/rising edge

[1] IC1: Output Interrupt Type

‘0’ = Level interrupt

‘1’ = Edge interrupt

[0] IC0: Global Interrupt Mask bit

When this bit is written a ‘1’, it will allow interruption to the host. If it is written with a ‘0’, then, it

disables all interruption to the host. Writing to this bit does not affect the INT_EN_MASK value.

STMPE1601 데이터시트(PDF) 25 Page - STMicroelectronics

STMPE1601 데이터시트(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

데이터시트 다운로드

링크 URL