TDA7580 datasheet(29/39 Pages) STMICROELECTRONICS

29 / 39 page

TDA7580

Functional description

29/39

8.2

DSP peripherals

●

Clock generation unit (CGU)

●

Stereo decoder (HWSTER)

●

Serial audio interface (SAI)

●

Tuner AGC keying DAC (KEYDAC)

●

Programmable I/O interface (I2C/BSPI)

●

Asynchronous sample rate converter (ASRC)

●

IF band pass sigma delta modulator (IFADC)

●

Digital down converter (DDC)

●

Discriminator (CORDIC)

●

RDS

●

Tuner diversity HS3I

The peripherals are mapped in the X memory space.

Most of them can be handled by interrupt, with software programmable priority.

Peripherals running at very high rate have direct access to X and Y data bus for very fast

movement from or to the core, by mean of single cycle instruction.

8.3

Clock generation unit (CGU) and oscillator

This unit is responsible for supplying all necessary clocks and synchronization signals to the

whole chip.

The control status register of this unit contains information about the current working mode

(oscillator [master mode] or clock buffer [slave mode]), the tuner clock frequency setting, the

general setup of the oscillator. This last function is performed inside the CGU, that

establishes using a self trimming algorithm, which is the current values that can bias the

oscillator: this feature lets the oscillator be independent from process parameters variation.

The values of bias current are stored in the control status register of the CGU: 4 bits for the

coarse current steps and 6 bits for the fine current steps.

In slave mode the oscillator behaves as a buffer: the chip can be then driven using an

external clock. The clock divider, placed in this unit, generates the tuner the reference clock

and can be programmed for frequencies down to 9KHz with selectable duty cycle and from

4.4Hz to 9KHz with duty cycle 50%.

An external clock can drive the XTI pin (please see

Table 12 for reference).

8.4

Stereo decoder (HWSTER)

The fully digital hardware stereo decoder does all the signal processing necessary to

demodulate an FM MPX signal which is prepared by the channel equalization algorithm in

the digital IF sampling device, providing pilot tone dependent mono/stereo switching, as well

as stereo-blend and highcut functionality.

Selectable de-emphasis time constant allow the use of this module for different FM radio

receiver standards.

TDA7580 데이터시트(PDF) 29 Page - STMicroelectronics

TDA7580 데이터시트(HTML) 29 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

데이터시트 다운로드

링크 URL