M41ST87WMX6TR datasheet(18/48 Pages) STMICROELECTRONICS

부품명	M41ST87WMX6TR

상세설명	5.0 V and 3.3/3.0 V secure serial RTC and NVRAM supervisor with tamper detection and 128 bytes of clearable NVRAM

PDF	48 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

18 / 48 page

Operating modes

M41ST87Y, M41ST87W

18/48

2.6.2

Tamper bits (TB1 and TB2)

If the TEBX bit is set, and a tamper condition occurs, the TBX bit will be set to '1.' This bit is

“Read-only” and is reset only by setting the TEBX bit to '0.' These bits are located in the flags

2.6.3

Tamper interrupt enable bits (TIE1 and TIE2)

If this bit is set to a logic '1,' the IRQ/OUT pin will be activated when a tamper event occurs.

This function is also valid in battery backup if the ABE bit (alarm in battery backup) is also

set to '1' (see Figure 14 on page 20).

Note:

In order to avoid an inadvertent activation of the IRQ/OUT pin due to a prior tamper event,

the flag register (0Fh) should be read prior to resetting the TEBX bit.

2.6.4

Tamper connect mode bit (TCM1 and TCM2)

This bit indicates whether the position of the external switch selected by the user is in the

normally open (TCMX = '1') or normally closed (TCMX = '0') position (see Figure 13 on

page 19 and Figure 15 on page 20).

2.6.5

Tamper polarity mode bits (TPM1 and TPM2)

The state of this bit indicates whether the tamper pin input will be taken high (to VOUT if

TPMX = '1') or low (to VSS if TPMX = '0') during a tamper event (see Figure 13 on page 19

and Figure 15 on page 20).

M41ST87WMX6TR 데이터시트(PDF) 18 Page - STMicroelectronics